សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 01 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 10:39 ព្រឹក
To program a remote control for your DOMINATOR 160443TBA Smart and Secure Sectional Door Openerសូមអនុវត្តតាមជំហានទាំងនេះ ដូចដែលបានរៀបរាប់នៅក្នុងសៀវភៅណែនាំអ្នកប្រើប្រាស់៖
1. **Storing the Remote Control Code:**
- Remove the controls cover to access the buttons.
- Press the MODE button repetitively until the REMOTE INDICATOR is lit.
- Press and HOLD the CLOSE button to set Open / Stop / Close function. The main light will start to flash rapidly.
- Press one of the four buttons on the transmitter until the main light starts to flash rapidly, then release the transmitter button.
- Press the remote control button again until the main light stops flashing.
- Release both buttons. Press the MODE button to exit and refit the controls cover. The remote button is now coded, press to test.
2. **Main Light Remote Status:**
- ON Button added: Main light flashes, then OFF.
- OFF Button removed: Main light flashes, then OFF.
- Remote control deleted: 2 flashes, then OFF.
- Memory full: 4 flashes, then OFF.
3. **Battery Replacement:**
- Battery Type: 1 x CR2032.
- To test the battery, press and hold a remote button. Check the Light Status table to determine if the battery needs replacing.
- Use finger nails to separate the remote casing to expose the circuit board.
- Use a non-metallic object to push the battery down through the side opening to remove it.
By following these steps, you can successfully program a remote control for your DOMINATOR 160443TBA Smart and Secure Sectional Door Opener.
បន្ថែមមតិយោបល់ថ្មី។