សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 30 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 03:53 យប់
To program a new remote control to work with the ELSEMA PCR43302RE 2-Channel 433MHz Penta Receiver, you can follow the steps outlined in the manual provided by ELSEMA:
1. **Remote to Receiver Programming:**
- Ensure that all switches are "OFF" on the receiver's 12-way dip switch.
- Press and hold the program button on the receiver.
- Press the button on the new remote control for 2 seconds. The receiver LED will flash and then turn Green.
- Release the buttons on both the receiver and the remote.
- Test the receiver output by pressing the button on the new remote control.
2. **Remote to Remote Programming:**
- If your receiver has a red marking, follow these steps:
- Open the case of a programmed remote control and press the program button on the back of the board to enter learning mode.
- Press the button of the programmed remote from step 1 to activate the receiver.
- Press the button on the new remote for 2 seconds.
- Press the program button again on the programmed remote to exit learning mode.
- Test the receiver output with the new remote control.
3. **Deleting Receiver's Memory:**
- To delete all remotes from the receiver's memory, short the Code Reset pins on the receiver for 10 seconds.
By following these programming instructions, you should be able to successfully add a new remote control to work with the ELSEMA PCR43302RE receiver for your automatic gate opener or other applications.
បន្ថែមមតិយោបល់ថ្មី។