សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 26 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 11:58 ព្រឹក
ដើម្បីសរសេរកម្មវិធី LiftMaster PPWR Passport Wiegand អ្នកទទួល to learn remote control transmitters, follow these steps:
1. **Initial PIN Set Up:**
- Upon initial power up, the system firmware revision is displayed for 5 seconds followed by the LiftMaster® logo. When a key is pressed, “CREATE PIN?” is displayed.
- Press “YES” to create a 6-digit PIN. If the PIN is lost, you can request a reset code by pressing "RESET" and following the provided instructions.
- Enter the 6-digit PIN, and press “YES”; enter the 6-digit PIN a second time and press “YES” to program the PIN. If you make a mistake, press “CLEAR” to change your entry.
- When your 6-digit PIN is programmed correctly, the LCD display reads “KEYPAD UNLOCKED”. Select “OK” to continue to the Main Menu.
2. **Choose a Mode of Operation:**
- The receiver has two modes of operation: Pass Through Mode (Default) and Advanced Mode.
- Select “MODE SELECT” from the main menu. Press “OK”.
- Choose the mode you want to use and press “YES”.
- Follow the prompts to confirm your selection and save the mode.
3. **Programming Remote Control Transmitters:**
- To program remote control transmitters, select “PROGRAM” from the Security Table menu. Press “OK”.
- Follow the on-screen instructions to save the facility code of the remote control transmitter.
4. **Editing Security Table and Facility Code Translation:**
- To edit the Security Table or set facility code translation, select “LIST” from the Security Table menu. Press “OK”.
- Use the navigation buttons to scroll through the Security Table and select an entry to edit.
- Follow the on-screen instructions to make changes to the facility code translation.
By following these steps, you can successfully program the LiftMaster PPWR Passport Wiegand អ្នកទទួល to learn and recognize remote control transmitters for access control purposes.
បន្ថែមមតិយោបល់ថ្មី។