សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 24 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 01:27 យប់
Before starting the cooler assembly, it is crucial to ensure compatibility between your graphics card and the ALPHACOOL Eisblock Aurora Acryl RTX 4080 Suprim cooler. Here are the steps to follow:
1. **Check Compatibility:** Compare your graphics card with the pictures in the configurator provided by Alphacool. Visit https://www.hwconfig.com and search for your graphics card or cooler model. Additionally, compare the PCB number for a definitive identification. The cooler was designed for a specific PCB layout, and any variations in the card's design may affect compatibility.
2. **Prepare Graphics Card:** Place your graphics card on an antistatic mat and begin dismantling the original cooler. Remove screws at the back of the card and carefully unhook the fan connector. If the original cooler uses thermal glue, handle it with extreme care to avoid damaging components. Clean the hardware of any thermal paste or pad residues using a solvent like isopropanol alcohol.
3. **Place Thermal Pads on Cooling Block:** Apply thermal pads on the cooling block as per the instructions provided in the manual.
4. **Apply Thermal Grease:** Apply thermal grease on the appropriate areas before installing the cooler.
5. **Install PCB:** Proceed with installing the PCB onto the cooler as instructed in the សៀវភៅដៃ.
6. **Mount PCI Bracket and Backplate:** Securely mount the PCI bracket and backplate to ensure proper installation.
7. **Connect ARGB Lighting:** Connect the ARGB lighting according to the provided instructions.
8. ** xxxx in xxxx Plugs:** Use the provided tool to xxxx in the xxxx plugs securely.
If you encounter any difficulties or have further questions during the installation process, you can contact Alphacool International GmbH for support using the contact information provided in the manual.
បន្ថែមមតិយោបល់ថ្មី។