សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 23 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 10:53 ព្រឹក
ដើម្បីភ្ជាប់ SCA-RC2 Dynamic Guideline Reverse Camera to your vehicle, follow these steps as outlined in the instruction manual:
1. **Mounting the Camera:** Ensure the camera does not obstruct the license plate or access to the boot release or tailgate latch.
2. **Power Connection:** Connect the RED wire of the video adapter cable to the wire supplying power to the reversing lamp. Use a suitable splicing/crimp connector or strip connector. Insulate the joint after making the connection.
3. ** វ៉ុលtage Consideration:** Some vehicles with LED or computer-controlled lighting systems may require a relay to supply power to the camera if the voltage at the reversing wire light is less than +12 volts. Test this using a multimeter.
4. **RCA Cable Connection:** Connect one end of the supplied RCA cable to the camera and run it to the front driver side dash area. Ensure the cable is hidden along the vehicle's side and under the dash.
5. **Monitor/Display Connection:** Depending on your monitor/display, connect the power wires as per the manual. Connect the RCA cable to the monitor/display loom.
6. **Testing:** Engage the park brake, turn the ignition key to the on position (without starting the vehicle), and select reverse gear. The monitor/display should turn on automatically when energized from the reverse light.
By following these steps, you can successfully install and connect the SCA-RC2 Dynamic Guideline Reverse Camera to your vehicle for enhanced safety while reversing.
បន្ថែមមតិយោបល់ថ្មី។