សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 22 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 01:40 យប់
To pair the control unit (transmitter) with the switching unit (receiver) on the EMOS P5614 ទែម៉ូស្ដាតឥតខ្សែអនុវត្តតាមជំហានទាំងនេះ៖
1. Ensure both thermostat units are paired before first use to enable the transfer of information between the control unit and the switching unit.
2. Remove the cover of the thermostat (transmitter) and insert 2× 1.5 V AAA batteries into the control unit, ensuring correct battery polarity. Only use alkaline batteries; do not use rechargeable batteries.
3. Correctly connect the switching unit to the voltage supply, turn the main switch to the "on" position, and long-press (for at least 10 seconds) the M/A button on the switching unit until a green diode starts flashing.
4. Long-press (for at least 3 seconds) the LEARN button on the thermostat's instrument panel.
5. The green diode on the switching unit will stop flashing, indicating that both units are now paired.
6. If you wish to change the pairing code of the two units, repeat the entire pairing procedure from step 1; the pairing code will be automatically rewritten.
7. If the thermostat is not functioning correctly, check the battery polarity, battery charge level, and reset the thermostat by removing and reinserting the batteries.
ការធ្វើតេស្តទំនាក់ទំនងឥតខ្សែរវាងអង្គភាព៖
- Set a temperature a few degrees higher than the current room temperature using the control wheel.
- The red LED on the switching unit will illuminate if the wireless communication is successful.
- If the LED does not light up, move the អង្គភាពត្រួតពិនិត្យ closer to the switching unit.
Remember, the maximum range between the control and switching unit is 100 meters in an open space, but this range may decrease indoors due to signal blockage by walls and obstacles.
បន្ថែមមតិយោបល់ថ្មី។