សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 17 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 12:03 យប់
If the wire feed is not working on the ម៉ាស៊ីនផ្សារ DEDEMAN AS130FULL, several factors could be causing this problem. Here are steps to troubleshoot and potentially resolve the issue based on the provided manual:
1. **Check Feed Cylinders, Wire Sleeve, and Contact Tips:**
- Ensure that the feed cylinders are not too tight or too loose.
- Inspect the condition of the wire sleeve and ensure it is not blocked or worn. Replace if necessary.
- Verify that the contact tip is suitable for the wire used and is not worn or blocked.
2. **Inspect Wire Size and Tension:**
- Check that the groove of the feed cylinders is not too worn, and the size for the filler wire used is correct.
- Ensure that the settings for thread tension and speed on the control panel are correct for the wire size and type being used.
3. **Verify Gas Flow and Shielding:**
- Check that the shielding gas flow at the gun nozzle is correct.
- Ensure that the shielding gas is suitable for the filler wire being used.
4. **Check Power Supply and Voltage:**
- Verify that the supply voltage is stable, not too low or too high, as this can affect the wire feed.
5. **Additional Troubleshooting:**
- If the issue persists, consider inspecting the power cord, welding cables, and connections for any damage that may be affecting the wire feed.
By following these troubleshooting steps outlined in the manual, you can identify and address potential causes of the wire feed issue on the DEDEMAN AS130FULL Welding Machine, ensuring smooth operation during your welding tasks.
បន្ថែមមតិយោបល់ថ្មី។