សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 03 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 10:49 យប់
ដើម្បីដំឡើងឱ្យបានត្រឹមត្រូវ JBA 1410S Cat4Ward Header on your vehicle, follow these steps as outlined in the instruction manual:
1. **Preparation:** Before starting the installation, ensure the vehicle is cool, disconnect the battery, and spray penetrating oil on all hardware and fittings that need to be removed.
2. **Removing Existing Parts:**
- From underneath the vehicle, remove the nuts connecting the exhaust to the catalytic converters.
- Remove bolts from the front exhaust hanger and push the exhaust system back.
- On the driver's side, remove the heat shield, O2 sensor plug, nuts attaching the converter to the manifold, and the manifold itself. Clean the sealing surface on the head.
- On the passenger side, remove the heat shield, O2 sensor, nuts attaching the cat. to the manifold, and the manifold itself. Raise the engine slightly for access.
3. **Installing the Header:**
- Install the header using the factory gasket and original nuts on both sides.
- Apply a thin bead of O2 sensor safe high-temperature silicone to the factory catalytic converter gasket.
- Reinstall the converter assemblies, reconnect O2 sensors, exhaust, and hanger.
- Check for adequate clearance on brake lines, fuel lines, coolant hoses, etc.
- Reconnect the battery cables, start the engine, and check for leaks.
4. **ជំហានចុងក្រោយ៖**
- Re-torque the header nuts after driving 50-100 miles.
- Reinstall the inner fender well and tire.
- Install the CARB sticker in an underhood location that is readily visible.
By following these detailed steps provided in the instruction manual, you can ensure a proper installation of the JBA 1410S Cat4Ward Header on your vehicle. Remember to refer to the manual for any specific details or precautions related to your vehicle model.
បន្ថែមមតិយោបល់ថ្មី។