សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 03 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 08:00 យប់
To configure the Modbus settings on the iSMACONTROLLI SFAR-S-16DI-M module, you can follow these steps based on the information provided in the instruction manual:
1. **ការចូលប្រើការចុះឈ្មោះ Modbus៖**
- The Modbus registers are used to configure various settings on the module.
- សម្រាប់ឧample, register 40003 (Hex: 0x03) allows you to read and write the RS485 baud rate setting.
2. **ការកំណត់អត្រា Baud:**
- To set the baud rate, you need to write the desired value to register 40003 (Hex: 0x03).
- អត្រា baud អាចត្រូវបានកំណត់រចនាសម្ព័ន្ធក្នុងចន្លោះពី 2400 ទៅ 115200 bps ។
3. **ការកំណត់រចនាសម្ព័ន្ធ Modbus Parameters ផ្សេងទៀត៖**
- Registers like stop bits, data bits, parity, response delay, and Modbus mode can also be configured using the respective register addresses provided in the manual.
4. **Reading Modbus Data:**
- You can read Modbus data from various registers such as inputs state, counters, and captured counter values.
5. **Counter Configuration:**
- Registers 40117 to 40132 (Hex: 0x74 to 0x83) allow you to configure the behavior of the counters, including time measurement, counter reset conditions, and encoder settings.
6. **Ensuring Correct Wiring:**
- Before configuring Modbus settings, ensure that the module is correctly wired to prevent damage and hazards.
- Follow the wiring guidelines provided in the manual to avoid electric shock or faulty operation.
7. **Contacting Support:**
- If you encounter any difficulties during the configuration process, you can reach out to the iSMA CONTROLLI Support Team at support@ismacontrolli.com for assistance.
By following these steps and referring to the specific Modbus register addresses mentioned in the manual, you can successfully configure the Modbus communication parameters on the iSMACONTROLLI SFAR-S-16DI-M module for seamless integration into your network.
បន្ថែមមតិយោបល់ថ្មី។