សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 03 ខែកញ្ញា ឆ្នាំ 2025 - ម៉ោង 06:18 យប់
To properly configure the switches on the ចូលទៅក្នុង INWFIFGL001R0XX AC Cloud Control, follow these steps based on the information provided in the installation guide:
1. **Header/Follower Configuration (Switch 1):**
- If you do not need a Wired Remote Controller, set Switch 1 to "1 X X X."
- If you have a Wired Remote Controller, set Switch 1 to "0 X X X."
2. **Indoor Unit Type (Switch 2):**
- For RAC inverter, RAC non-inverter, VRF V, VRF S, or VRF J units, set Switch 2 to "X 1 X X."
- For RAC inverter model G series, VRF J-II, VRF V-II, or VRF VR-II 10 units, set Switch 2 to "X 0 X X."
3. **Performance Mode (Switch 3):**
- For High-Performance Mode (default), set Switch 3 to "X X 1 X."
- For Low-Performance Mode, set Switch 3 to "X X 0 X."
4. **Wi-Fi Range (Switch 4):**
- For Maximum Wi-Fi range (default), set Switch 4 to "X X X 1."
- For Minimum Wi-Fi range, set Switch 4 to "X X X 0."
5. **កំណត់ចំណាំសំខាន់ៗ៖**
- High-Performance mode consumes more power but provides maximum performance.
- Adjusting Wi-Fi range may impact communication, so choose the appropriate setting for your installation.
- If the AC Cloud Control reboots due to excessive port consumption, adjust Switches 3 and 4 to reduce consumption.
6. **Saving Switch Setup:**
- To save the switch setup, disconnect the indoor unit from the main power or the AC Cloud Control from the Indoor Unit.
By following these switch configurations based on your specific requirements, you can ensure that the ចូលទៅក្នុង INWFIFGL001R0XX AC Cloud Control operates optimally and meets your needs effectively.
បន្ថែមមតិយោបល់ថ្មី។