សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ខែសីហា 31, 2025 - 10:53 PM
**Installation Guidelines:**
1. **Direction of Flow:** The valve must be installed with the arrow indicating the direction of flow and the top cover facing upwards.
2. **Rotation:** The top cover can be rotated 4 X 90° in relation to the valve body for flexibility in installation.
3. **Piping Installation:** Follow the recommended piping installation and distances as shown in the provided diagram (fig. 7) to achieve optimized dampលទ្ធផល។
4. **Pipe Clamps:** Install strong and robust pipe clamps at designated positions (A and B) to prevent exceeding vibrations caused by the ICD eigenfrequency. These clamps must meet the minimum stiffness values specified in the manual.
5. **Welding:** Before welding, remove the top assembly to prevent welding debris from entering the module. Use welding materials and methods compatible with the valve body material. Clean the valve internally after welding to remove debris.
6. **Assembly:** Remove welding debris and dirt from pipes and valve body before assembly. Check the integrity of the o-ring and gasket before reassembly.
7. **Tightening:** Use a torque wrench to tighten the top cover to the specified values indicated in the manual (refer to fig. 6).
8. **Maintenance:** The ICD valves are easy to dismantle for servicing. Do not open the valve while it is under pressure. Use only original Danfoss parts for replacement gaskets.
**Note:** Always refer to the official ដាន់ហ្វូស ICD 32 and 50 Pressure Module for ហ្គាស ឃamping Installation Guide for detailed and accurate instructions to ensure proper installation and operation of the product.
បន្ថែមមតិយោបល់ថ្មី។