សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ខែសីហា 29, 2025 - 08:58 PM
នេះបើតាម LiftMaster 041-0347-000 Camera Service Kit Replacement Instruction Manual, here are the steps to connect the new camera to your myQ® account:
1. **Disconnect Power:** Before starting any service or maintenance, ensure all electric and battery power is disconnected to prevent any possible injury or accidents.
2. **Remove Old Camera:** Unscrew the old camera from the opener housing by removing the three screws with a Phillips screwdriver. Disconnect the wire harnesses carefully.
3. **Install New Camera:** Place the new camera into the garage door opener, aligning the xxxx holes, and fasten the three screws with a Phillips screwdriver. Reattach the decorative badge.
4. **Reconnect Power:** Once the new camera is securely installed, reconnect the power and battery if used.
5. **Connect to myQ® Account:** Locate the notch in the camera's opener and pull down. Follow the instructions on the myQ® app to add the new camera to your myQ® account. Make sure to delete the garage door opener from the myQ account before re-adding it along with the new camera.
By following these steps, you should be able to successfully replace the camera service kit on your LiftMaster garage door opener and connect the new camera to your myQ® account for remote monitoring and control.
បន្ថែមមតិយោបល់ថ្មី។