សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ខែសីហា 28, 2025 - 08:45 PM
If you need to reset your រូជី RG-RAP6262 Outdoor Omni-Directional Access Point to factory settings, follow these steps as outlined in the user manual:
1. **Restart the Access Point:**
- Press and hold the pin to the Reset hole for less than 2 seconds. This action will restart the access point.
2. **Restore the Access Point to Factory Settings:**
- Press and hold the pin to the Reset hole for more than 5 seconds. This will restore the access point to its factory settings.
It's important to note that when the System Status LED is flashing twice in succession, it indicates various scenarios where you might need to reset the access point to factory settings, such as restoring it to default settings, upgrading firmware, or handling alarms automatically. Make sure not to power off the access point during these processes.
ដោយធ្វើតាមជំហានទាំងនេះ អ្នកអាចកំណត់ឡើងវិញបានយ៉ាងងាយស្រួល រូជី RG-RAP6262 Outdoor Omni-Directional Access Point to factory settings when necessary.
បន្ថែមមតិយោបល់ថ្មី។