សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 28 ខែសីហា ឆ្នាំ 2025 - 04:15 ព្រឹក
ដើម្បីដំឡើងឱ្យបានត្រឹមត្រូវ គាំទ្រfile រចនា Ergo+ & Race+ Armrest Kits, you will need the following tools and materials: a 4mm Hex Wrench, a Torque Wrench with a 4mm hex bit, and grease such as Finish Line Premium Grease. The Armrest kit should contain two armrest cups with hook & loop stickers, two armpad cushions (foam), and four M6x15 countersunk bolts.
Here are the steps to follow for installation:
1. Apply a light coating of grease to the surface of the armrest mount to protect against corrosion.
2. Fasten the armrests to the brackets using the M6x15mm countersunk bolts. Note that the armrests have an offset design, so ensure each side is positioned in the same way.
3. Torque the bolts to 4.7Nm using the torque wrench.
4. Apply a light coating of grease to the surface of the bolts as a protective layer against the effects of sweat.
5. Attach the cushion by placing it carefully on the hook and loop backing of the armrest and hold firmly for 30 seconds. Repeat for the other armrest. Note that the cushions on these models of armrest are symmetrical, so it doesn’t matter which side each cushion is applied to.
For installing new armpads, follow these steps:
1. Ensure the inner face of the armrest is free of lint and grease. If the armrest previously had a hook and loop sticker applied, remove any residue mechanically or with a citrus-based solvent.
2. Wipe down the surface with isopropyl alcohol before applying the hook and loop sticker. Remove the backing from the sticker and apply it to the armrest, smoothing it out to ensure no air bubbles are trapped underneath.
3. Allow the sticker 24 hours to cure before use.
Remember not to put force on the side of the armrests during usage. If you encounter any issues or have further questions, you can refer to the Profile Design Worldwide Two Year Limited Warranty or contact គាំទ្រfile រចនា សេវាកម្មអតិថិជនសម្រាប់ជំនួយ។
បន្ថែមមតិយោបល់ថ្មី។