សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 27 ខែសីហា ឆ្នាំ 2025 - 03:25 ព្រឹក
ដើម្បីដំឡើងឱ្យបានត្រឹមត្រូវ ក្រុមហ៊ុន JJ Electronics TPL-P120-300-50 PureWhite Incandescent Pool and Spa Light Fixture in an existing pool or spa, follow these steps:
1. **Ensure Electrical Requirements:** Confirm that the pool or spa meets all current National Electrical Code (N.E.C.) Article 680-22 requirements and any applicable local codes or ordinances. The electrical system must be installed by a licensed or certified electrician to meet or exceed those requirements prior to installation of the light.
2. **Disconnect Power:** Always disconnect power to the pool and/or spa light at the circuit breaker panel before attempting to service the light to avoid the risk of electrical shock.
3. **Remove Existing Light:** Follow the original manufacturer's instructions to remove the existing light fixture and place it on the deck.
4. **Cut and Replace Cord:** Leaving the light fixture on the deck, cut the light cord, leaving at least six (6) inches of cord to connect it to the replacement light cord. Remove the existing cord by pulling it up out of the niche and onto the deck.
5. **Connect New Light Cord:** Carefully strip the outer cord jacket from the new light cord to expose six (6) inches of the underlying three insulated wires. Tape the three existing light wires to the replacement light cord with electrical insulating tape.
6. **Connect Wires:** After removing the junction box cover, disconnect the light fixture wires. Pull the cord through the conduit until it is visible in the junction box conduit. Remove the tape from the cords and separate the wires. Connect these three (3) wires to their corresponding junction box circuit wires and secure the junction box cover in place.
7. **Install Light Fixture:** Install the Purewhite® Incandescent light fixture into the niche using the stainless steel pilot xxxx provided. Carefully tighten the pilot xxxx .
8. **Test Operation:** Make a final check to confirm proper light operation by switching on the main switch or circuit breaker and the light switch. The light should illuminate when power is switched on. If the light is not operating, recheck each installation step for proper completion.
By following these steps and ensuring compliance with all safety and installation guidelines provided in the manual, you can successfully install the ក្រុមហ៊ុន JJ Electronics TPL-P120-300-50 PureWhite Incandescent Pool and Spa Light Fixture in your existing pool or spa.
បន្ថែមមតិយោបល់ថ្មី។