សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ខែសីហា 26, 2025 - 08:15 PM
To connect multiple sections of តេត្រា LED Tape Gen 2 together, you can use the Lead Connector (GETPLCN54-1) and Jumper Connector (GETPLCN54-1) components provided. The Lead Connector is used to connect the power supply to the LED tape, while the Jumper Connector is used to connect multiple sections of LED tape together.
Here's how you can connect multiple sections of Tetra LED Tape Gen 2 together:
1. Use the Lead Connector to connect the power supply to the starting point of the LED tape.
2. Use the Jumper Connector to connect the end of one section of LED tape to the beginning of the next section.
3. Make sure to align the positive and negative terminals correctly when connecting the sections together.
4. Repeat this process for each additional section of LED tape you want to connect.
By following these steps and using the provided connectors, you can easily connect multiple sections of តេត្រា LED Tape Gen 2 together to create a longer lighting setup.
បន្ថែមមតិយោបល់ថ្មី។