សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 21 ខែសីហា ឆ្នាំ 2025 - 04:26 ព្រឹក
To adjust the fence faces on the POWERTEC 71536 24 Inch Router Table Fence for different routing operations, follow these steps:
1. **Setting Up for Zero-Clearance Support:**
- Set the bit height and fence position with the MDF adjustable fence faces close to the bit without touching it.
- Install, adjust, and secure the bit guard.
- Loosen the locking knobs on the infeed MDF adjustable fence face, start the router, and slowly slide the infeed face into the spinning router bit until it reaches the guide bearing or midpoint.
- Tighten the locking knobs to secure the infeed face in position.
2. **Converting from Inboard to Outboard Position:**
- Remove the xxxx and T-bolt, rotate the stop body 180°, and then replace the xxxx and T-bolt.
3. **Jointing Operation:**
- Offset the outfeed fence face by sliding jointing rods into grooves behind the fence faces.
- Use two sets of grooves for different offsets: 3/128", 1/16", 5/64".
- Adjust the fence faces and jointing rods as needed to align the bit and achieve the desired jointing results.
4. **General Maintenance:**
- Keep the router table fence dry, clean, and free from oil and grease.
- Use a clean cloth for cleaning; avoid using strong solvents that can damage the plastic components.
- Ensure all repairs are performed by a qualified service technician using identical replacement parts.
ដោយអនុវត្តតាមជំហានទាំងនេះ និងការណែនាំពី ស សៀវភៅដៃរបស់ម្ចាស់, you can adjust the fence faces on the router table fence accurately for various routing tasks, ensuring both quality results and safety during operation.
បន្ថែមមតិយោបល់ថ្មី។