សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ខែសីហា 20, 2025 - 10:38 PM
ដើម្បីភ្ជាប់របស់អ្នក។ ប្រសព្វ Solo6 Studio Monitor to your audio source, follow these steps:
1. **Check the Settings:** Ensure that both the loudspeakers and the audio source are turned off, and all settings at the back of the loudspeakers are in the 0 position. Make sure the sensitivity switch is set to +4dBu.
2. **Audio Signal Connection:** Connect the audio signal from your source to the loudspeakers using XLR inputs.
3. **Power Connection:** Use the power cable provided to connect the loudspeaker to the mains power.
4. **Audio Source Power:** Power on the audio source and set the output level to - ∞ or a very low level.
5. **Power On:** Switch on the loudspeakers. They will be in "Stand-by" mode initially.
6. **Signal Detection:** Increase the level of the audio source gradually until the signal is detected by the loudspeakers, causing them to switch to "On" mode automatically.
After following these steps, your ប្រសព្វ Solo6 Studio Monitor should be properly connected to your audio source and ready for use.
បន្ថែមមតិយោបល់ថ្មី។