សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 20 ខែសីហា ឆ្នាំ 2025 - 04:37 ព្រឹក
To program a transmitter with the TRIO2SYS EnOcean 16A DIN Rail Switch Receiver, follow these steps as outlined in the manual:
1. Make sure the receiver is connected to the mains power.
2. Use a small insulated screwdriver to activate the LRN or CLR buttons on the receiver.
3. To enter programming mode, short press (approximately 0.5s) the LRN button. The LED will flash regularly to confirm you are in programming mode.
4. To associate a transmitter, simply press on one of the switches on the transmitter or press the LRN button on the receiver. The receiver will acknowledge the recording in memory by keeping the LED on for 4 seconds. You can then associate another transmitter or clear a transmitter.
5. To clear a transmitter, press on one of the switches on the transmitter or press the LRN button of the desired sensor. The receiver will acknowledge the clearing by keeping the LED off for 4 seconds.
6. You can also use the EnOcean UTE1 protocol for association or deletion of transmitters. Once the relay output has been chosen, send a UTE Query1 type frame. The association or deletion is confirmed by keeping the LED on or off for 4 seconds and by sending a UTE Response1 type frame.
7. To exit programming mode, short press (approximately 0.5s) the LRN button. The regular flashing of the LED will stop to confirm you have exited programming mode.
កំណត់ចំណាំបន្ថែម៖
- No transmitter is programmed in the receiver in the supplied state.
- When using BMS products, programming must be done alone and channel by channel.
- Up to 32 transmitters, switches, or sensors can be allocated to each channel.
- If the memory is full, the receiver exits programming mode upon an additional association attempt.
- The transmitters are alternatively programmed or cleared in the event of several activations.
- Learn mode stops automatically after 30 seconds if no button is pressed.
By following these steps, you should be able to successfully program your transmitter with the TRIO2SYS EnOcean 16A DIN Rail Switch Receiver.
បន្ថែមមតិយោបល់ថ្មី។