សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ខែសីហា 18, 2025 - 10:09 PM
To program a new sensor or replace a missing sensor in the អូរីខម TPS10-4I Real Time Tyre Pressure ប្រព័ន្ធត្រួតពិនិត្យអនុវត្តតាមជំហានទាំងនេះ៖
1. Press the "" button 5 times to enter programming mode. The display will beep once to indicate it's in programming mode.
2. Select the desired tyre position by following these steps:
- Hold the “ ” button and press the “ ” button once to select the interface. (Interface sequence: tow vehicle → Axle A of Trailer → Axle B of Trailer → Spare tyre)
- Press the “ ” button to select the desired tyre.
3. Deflate the corresponding tyre slightly.
4. The corresponding tyre data will be shown on the display. Press the “ ” button once to save the data.
5. Press the “ ” button to select the next sensor position.
6. After programming all sensors, press the “ “ button for 4 seconds to exit the programming mode.
Make sure to follow these steps carefully to ensure the new sensor is correctly programmed and integrated into the tyre pressure monitoring system.
បន្ថែមមតិយោបល់ថ្មី។