សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 14 ខែសីហា ឆ្នាំ 2025 - 01:53 ព្រឹក
ដើម្បីរៀបចំរបស់អ្នក។ ឧបករណ៍វាយតម្លៃ JAVAD TRE for testing and evaluation, follow these steps based on the information provided in the manual:
1. OEM Board Connection:
- Connect the OEM board of the TRE series directly to the Evaluation Kit using its 64-pin DIN41612 Euro connector.
2. ការភ្ជាប់អង់តែន GNSS៖
- Connect the OEM board to an external GNSS antenna using the TNC to MMCX RA Antenna cable provided in the kit. You may also need to purchase an external GNSS Antenna Cable separately.
3. ការតភ្ជាប់ថាមពល៖
- Power the OEM board through the Evaluation Kit using the Power Cable included in the kit. Connect the Banana plugs of the power cable to a suitable laboratory power supply, battery, or other power source with the required specifications.
4. Serial RS-232 Connection:
- Use a standard Null-Modem cable with DE-9 Female connectors on both ends to connect the PC COM port with the Serial ports on the Evaluation Kit for data exchange.
5. Serial RS-422 Connection:
- Use a Null-Modem RS-422 cable to connect two OEM receivers together or to connect an OEM receiver with external devices for data exchange.
6. ការតភ្ជាប់ USB៖
- Use a standard USB 2.0 High-Speed cable to connect the OEM receiver to a PC through the USB port on the Evaluation Kit.
7. ការតភ្ជាប់អ៊ីសឺរណិត៖
- Use a high-quality UTP 5 or 5e category cable with RJ45 Male connectors to connect the OEM receiver to a LAN, PC, or another OEM receiver directly.
8. ការតភ្ជាប់អាច៖
- Use a Direct CAN cable to connect two OEM receivers together via the CAN interface for data exchange.
Ensure to follow the wiring diagrams and instructions provided in the manual for each type of connection to ensure proper setup and functionality of the កញ្ចប់វាយតម្លៃ. If you encounter any issues during setup, refer to the manual for troubleshooting steps or contact your local dealer for technical assistance.
បន្ថែមមតិយោបល់ថ្មី។