សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ខែសីហា 03, 2025 - 10:44 PM
To replace the cutting line on the Kobalt KST 2224B-03 Brushless String Trimmerអនុវត្តតាមជំហានទាំងនេះ សៀវភៅណែនាំអ្នកប្រើប្រាស់:
1. Press the two release tabs on the spool base and remove the spool retainer by pulling it straight out.
2. Remove the spool and clean the inner surface of the spool retainer and spool base.
3. Take approximately 15 ft. of 0.08 in. diameter cutting line. Fold the line in half and adjust it so that one end is longer than the other.
4. Hook the folded end of the cutting line onto either of the slots in the spool.
5. Wind the line, in two even and tight layers, onto the spool in the direction indicated on the spool.
6. Place the ends of the line in two opposite notches in the spool, with approximately 5 in. protruding.
7. Align the notches of the spool with the eyelets in the spool retainer and position the spool in the retainer.
8. Pull one end of the line to release it from the notch in the eyelet. Repeat with the other end.
9. Align the slots in the spool retainer with the tabs on the spool base and press the retainer down until it snaps into place.
Make sure to follow these instructions carefully to ensure proper replacement of the cutting line on your Kobalt string trimmer.
បន្ថែមមតិយោបល់ថ្មី។