សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 01 ខែសីហា ឆ្នាំ 2025 - 01:52 ព្រឹក
នេះបើយោងតាមសៀវភៅណែនាំសម្រាប់គ PRODEMAND 65 12 072 អង្គភាពប្រធានវិទ្យុ, here are the steps to properly remove and replace the ampរស់រានមានជីវិត៖
1. ការងារបឋម៖
- Disconnect the BATTERY EARTH LEAD.
- Remove the FLAP IN LUGGAGE COMPARTMENT TRIM PANEL ON THE LEFT.
2. ការដក Ampរស់រានមានជីវិត៖
- Disconnect the plug connection.
- Release the xxxx and slide the amplifier in the direction of the arrow out of the mounting.
3. Installation of Cable Jumper:
- Install a cable jumper consisting of a socket and wire jumper in the connector.
- Create a wire jumper from wire (cross-section 0.75 mm2) and two stops. Connect pins 1 and 2 in the socket with the wire jumper.
4. កំណត់សម្គាល់ការដំឡើង៖
- Tabs must be correctly slid into the guide. Ensure that the amplifier is securely seated.
5. ការជំនួស៖
- Carry out PROGRAMMING/ENCODING.
It is essential to follow the instructions carefully to prevent any damage or issues. If you have a vehicle with a production date up to 09/2010, you may need to carry out a conversion in the diagnosis system. For vehicles produced after 09/2010, no vehicle programming/encoding is required.
Always refer to the specific instructions provided in the manual for your PRODEMAND 65 12 072 Radio Head Unit to ensure the correct and safe removal and replacement of the ampកាន់តែចាស់។
បន្ថែមមតិយោបល់ថ្មី។