សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 29 ខែកក្កដា ឆ្នាំ 2025 - ម៉ោង 03:14 ព្រឹក
To set the DIP switches for the aftermarket radio you are using with the ចំណុចប្រទាក់ជំនួសវិទ្យុ CRUX SWRHN-62Bអនុវត្តតាមជំហានទាំងនេះ៖
1. Plug in the 3.5MM to 4-Pin SWC cable into the interface.
2. Locate the DIP switches on the interface. These switches are used to configure the steering wheel control settings for your aftermarket radio.
3. Refer to the aftermarket radio DIP switch settings provided in the manual. These settings will vary depending on the brand and model of your aftermarket radio.
4. Set the DIP switches on the interface according to the recommended settings for your specific aftermarket radio. Ensure that the switches are in the correct position based on the instructions provided.
5. If your aftermarket radio does not have a 3.5mm SWC jack, use the supplied 3.5MM SWC plug adapter to connect the steering wheel controls.
6. Insulate any unused wires, such as the Blue/Yellow or Green/Black wires, to prevent interference or short circuits.
By correctly setting the DIP switches on the CRUX SWRHN-62B interface to match your aftermarket radio, you will be able to retain factory steering wheel controls and ensure seamless integration with your Honda vehicle.
បន្ថែមមតិយោបល់ថ្មី។