សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 28 ខែកក្កដា ឆ្នាំ 2025 - ម៉ោង 11:54 យប់
ការដំឡើង៖
1. All installation work must be performed by a licensed electrician and comply with national, state, and local codes.
2. Ensure proper drainage for electrical components.
3. Use a ground-fault interrupter (GFCI) for underwater lighting fixtures.
4. Connect the terminal bar to the grounding means in the electric supply service panel.
5. Provide a suitably rated switch or circuit breaker to open all ungrounded supply conductors.
6. Ensure proper sizing of supply conductors to support all loads.
7. Follow CE Certification guidelines for power ratings.
8. Follow plumbing requirements as per local codes and recommended hydraulic schematics.
ប្រតិបត្តិការ៖
1. Always exercise caution when operating or servicing the system.
2. Do not permit children to use the system without close supervision.
3. Avoid prolonged immersion in hot water to prevent hyperthermia.
4. Do not use alcohol, drugs, or medication before using the system.
5. The system is intended to control heaters with built-in high limit circuits only.
6. Do not use the system to control an automatic pool cover.
7. Ensure a clearly labeled emergency switch is provided for units used in other than single-family dwellings.
8. Keep all equipment at least 10 ft. away from the water's edge.
9. Follow proper high voltage connection procedures.
10. Install the Power Center or Load Center enclosure as per the provided instructions.
For more detailed information and specific steps, please refer to the ប្រព័ន្ធគ្រប់គ្រង Intellitouch PENTAIR WWP-7696 សៀវភៅណែនាំ.
បន្ថែមមតិយោបល់ថ្មី។