សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 25 ខែកក្កដា ឆ្នាំ 2025 - ម៉ោង 09:44 ព្រឹក
If the suction performance of your Mirka 1025 L Dust Extractor drops, you can follow these steps to clean the filter element:
1. **Switch off the dust extractor:** Before starting the cleaning process, ensure that the dust extractor is switched off and unplugged from the power source.
2. **Close the nozzles or suction hose opening:** Cover the nozzles or suction hose opening with the palm of your hand to prepare for the filter cleaning process.
3. **Start the filter cleaning process:** Press the button to start the filter cleaning. Repeat this process at least three times for two seconds each. The resulting stream of air will remove attached dust from the slats of the filter elements.
4. **Check suction power:** After the filter cleaning process, check if the suction power has improved. If the suction power is still too low, it may be necessary to replace the filter.
Remember to always refer to the operating manual for detailed instructions on cleaning and maintaining your Mirka 1025 L Dust Extractor.
បន្ថែមមតិយោបល់ថ្មី។