សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 25 ខែកក្កដា ឆ្នាំ 2025 - ម៉ោង 04:52 ព្រឹក
ដើម្បីដំឡើង VIMAR 01401 Smart Automation By-Me Plus power unit on DIN rails, follow these steps as per the instruction manual:
1. **Qualified Personnel:** Installation should be carried out by qualified personnel in compliance with the current regulations regarding the installation of electrical equipment in your country.
2. **Location:** Install the device at a height of no more than 2 meters.
3. **Surge Protection:** An SPD (surge protection device) must be installed upstream from the device to reduce the overvoltagប្រភេទ e ពី III ដល់ II ។
4. **Secure Installation:** To prevent injury, secure the appliance to the wall as described in the installation instructions. Above the power supply, there must be a bipolar circuit breaker that is easily accessible with a contact gap of at least 3 mm.
5. **Safety Precautions:** Ensure there are no dripping or splashes of water on the appliance during installation.
6. **Conformity:** The product complies with LV directive, EMC directive, RoHS directive, and standards EN 62368-1, EN 61000-6-3, EN 50130-4, EN 50491, EN 50581.
7. **Disposal:** If the crossed-out bin symbol appears on the equipment or packaging, do not include the product with other general waste at the end of its working life. Take the worn product to a sorted waste center or return it to the retailer when purchasing a new one for environmentally friendly disposal.
By following these installation rules and safety precautions, you can ensure the proper installation and use of the VIMAR 01401 Smart Automation By-Me Plus power unit on DIN rails.
បន្ថែមមតិយោបល់ថ្មី។