សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 02 ខែកក្កដា ឆ្នាំ 2025 - ម៉ោង 12:07 យប់
ដើម្បីផ្គូផ្គង ZigBee 4 in 1 Multi Sensor with your ZigBee gateway or hub, follow these steps:
1. **Remove from Previous ZigBee Network:** If the sensor has already been added to a ZigBee network, you need to remove it before pairing it again. You can refer to the "Factory Reset Manually" section in the user manual for instructions on how to perform a factory reset.
2. **Enter Pairing Mode:** From your ZigBee gateway or hub interface, choose to add a device and follow the instructions to enter pairing mode. You can use one of the following methods to initiate pairing:
- Method 1: Short press the "Prog." button on the sensor 3 times continuously within 1.5 seconds. The LED indicator will flash rapidly, indicating that the sensor is in network pairing mode (beacon request) for 60 seconds. If the timeout occurs, repeat this step.
- Method 2: If the device has not been paired to any ZigBee network, reset the power of the device by removing and reinstalling the batteries. The sensor will enter network pairing mode automatically for 10 seconds. If the timeout occurs, repeat this step.
3. **Pairing Confirmation:** The LED indicator will stay solid on for 3 seconds if the device is successfully paired to the network. At this point, the device will appear in your gateway's menu and can be controlled through the gateway or hub interface.
4. **Verification:** To check whether the device has been successfully added to a ZigBee network, you can use the following methods:
- Method 1: Short press the "Prog." button. If the LED indicator stays solid on for 3 seconds, it means the device has been added to a network. If the LED indicator blinks 3 times slowly, it means the device has not been added to any network.
- Method 2: Reset the power of the device by removing and reinstalling the batteries. If the LED indicator blinks rapidly, it means the device has not been added to any network. If the LED indicator stays solid on for 3 seconds, it means the device has not been added to any network.
By following these steps, you should be able to successfully pair the ZigBee 4 in 1 Multi Sensor with your ZigBee gateway or hub for smart home automation applications.
បន្ថែមមតិយោបល់ថ្មី។