សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 20 ខែមិថុនា ឆ្នាំ 2025 - ម៉ោង 03:56 ព្រឹក
To test if your AJAX DoorProtect Plus detector is functioning properly, you can follow these steps:
1. **Performance Testing:** The AJAX security system allows you to conduct tests to check the functionality of connected devices. The tests do not start immediately but within 36 seconds by default. The starting point for the test can be initiated through the AJAX app.
2. **Installing the Detector:**
- The location of the DoorProtect Plus should consider its distance from the hub and any obstacles hindering radio signal transmission, such as walls, floors, or large objects inside the room.
- If the signal level is low, take measures to improve signal quality by moving the detector closer to the hub. A 20 cm shift can significantly improve signal reception.
- If signal strength remains low or unstable, consider using a ReX radio signal range extender.
3. **Detector Testing:**
- Fix the detector and magnet with the provided adhesive tape.
- Use the Detection Zone test mode to check the operation of the detector. In this mode, the LED will light continuously and switch off for a second if the detector is triggered.
- Test the device by opening and closing the door several times to ensure correct operation.
By following these steps, you can ensure that your AJAX DoorProtect Plus detector is functioning properly and effectively securing your premises.
សម្រាប់ព័ត៌មានលម្អិតបន្ថែម និងការណែនាំជាក់លាក់ សូមមើល សៀវភៅណែនាំអ្នកប្រើប្រាស់ AJAX DoorProtect Plus ផ្តល់ជូនជាមួយផលិតផល។
បន្ថែមមតិយោបល់ថ្មី។