សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 11 ខែមិថុនា ឆ្នាំ 2025 - ម៉ោង 01:32 ព្រឹក
ដើម្បីដំឡើង MaxLite FRK Series Round Retrofit Kit in your existing luminaire, follow these steps as outlined in the instruction manual:
1. **Disconnect Power:** Before starting the installation process, turn off the power by either switching off the circuit breaker or removing the appropriate fuse at the fuse box. Do not rely on just turning off the light switch.
2. **Removing Un-Needed Parts:**
- Shut off the power at the circuit breaker.
- Remove the diffuser, old sockets, and lead wires, but retain all other parts including the crossbar.
- Twist the ceiling pan to loosen and remove it via the keyhole slots to access the junction box.
3. **ជំហានដំឡើង៖**
- Route the LED retrofit kit wire harness wires (1 white, 1 black) and ground wire (1 green) through the wire opening in the fixture. Ensure the wires will not be pinched by the round LED mounting plate or other fixture hardware.
- Secure the retrofit to the fixture using one of the three installation options available:
- Connect wire harness leads to mains wiring inside the junction box using wire nuts/connectors (WAGO):
- Green wire to ground wire (bare or green)
- Black or blue wire to line conductor (black)
- White wire to neutral conductor (white)
- Place the provided label in the outer space of the luminaire after the LED engine installation is completed. The label must be visible.
- Re-attach and secure the lens to the luminaire. The luminaire will work with or without the diffuser.
4. **ព័ត៌មានការធានា៖**
- The product is covered by a warranty for a minimum period of five years from the date of original purchase. Refer to MaxLite's website for complete warranty terms and conditions.
By following these installation steps and safety precautions outlined in the manual, you can successfully install the MaxLite FRK Series Round Retrofit Kit in your existing luminaire.
បន្ថែមមតិយោបល់ថ្មី។