សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ឧសភា 24, 2025 - 09:20 AM
នេះ។ Pacto 2000H offers several ways to switch between different modes:
1. **No dedicated mode controls:** Use shortcuts instead by holding various start and select buttons for 8 seconds.
2. **Buttons:** Wire buttons to enter each mode.
3. **Switches:** Attach a single pole switch, while the opposite mode is grounded. Refer to the switch wiring guide for which ones to ground.
សម្រាប់អតីតample, to enable Twinstick Mode, you would ground the !TS Pin (!TS = NOT Twinstick) and connect the TS Pin to a switch, then connect the other side of the switch to ground.
It is also possible to use a combination of switches and buttons as desired. Each mode button is connected to its respective input pin on one side and ground on the other side. Switches should be wired according to the instructions provided in the manual for each specific mode.
Remember that the board starts in analog fast mode on startup, and if you would like to permanently enable a mode other than the default, you can install a jumper from the desired mode pins to ground. Otherwise, they will return to default when the power is cycled.
By following the wiring instructions provided in the សៀវភៅដៃ and using the dedicated mode selection input pins, you can easily switch between different modes on the Pacto 2000H control interface for your arcade cabinet.
បន្ថែមមតិយោបល់ថ្មី។