សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ឧសភា 09, 2025 - 08:20 AM
To connect and power up the PROSCEND 211P Gigabit PoE Injectorអនុវត្តតាមជំហានទាំងនេះ៖
1. ** ការតភ្ជាប់ថាមពល៖ **
- Connect the power cord to the "Power" interface on the PoE injector.
- Plug the other end of the power cord into a power outlet with a voltage rating between 100-240 VAC.
2. **Ethernet Network Connection:**
- Connect your Ethernet network cable to the "DATA IN" interface on the PoE injector.
- Connect the other end of the Ethernet cable to your network device or switch.
3. **Powering the Device:**
- Connect the powered device (PD) to the "DATA & POWER OUT" interface on the PoE injector.
- Make sure the device you are powering supports PoE.
4. **LED Indicators:**
- Check the LED indicators on the front panel of the PoE injector.
- The "AC" LED should be green when the device is powered on and off when it's off.
- The "PORT" LED should be green when PoE power output is on and off when it's off.
By following these steps, you should be able to properly connect and power up the PROSCEND 211P Gigabit PoE Injector. If you encounter any issues, refer to the installation guide or contact PROSCEND customer support for assistance.
ឧសភា 09, 2025 - 08:21 AM
To connect and power up the PROSCEND 211P Gigabit PoE Injectorអនុវត្តតាមជំហានទាំងនេះ៖
1. ** ការតភ្ជាប់ថាមពល៖ **
- Connect the power cord to the "Power" interface on the PoE injector.
- Plug the other end of the power cord into a power outlet with a voltage rating between 100-240 VAC.
2. **Ethernet Network Connection:**
- Connect your Ethernet network cable to the "DATA IN" interface on the PoE injector.
- Connect the other end of the Ethernet cable to your network device or switch.
3. **Powering the Device:**
- Connect the powered device (PD) to the "DATA & POWER OUT" interface on the PoE injector.
- Make sure the device you are powering supports PoE.
4. **LED Indicators:**
- Check the LED indicators on the front panel of the PoE injector.
- The "AC" LED should be green when the device is powered on and off when it's off.
- The "PORT" LED should be green when PoE power output is on and off when it's off.
By following these steps, you should be able to properly connect and power up the PROSCEND 211P Gigabit PoE Injector. If you encounter any issues, refer to the installation guide or contact PROSCEND customer support for assistance.
បន្ថែមមតិយោបល់ថ្មី។