សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ឧសភា 03, 2025 - 02:11 AM
ដើម្បីកំណត់រចនាសម្ព័ន្ធ BR-RC1190-Mod ម៉ូឌុលឧបករណ៍បញ្ជូន RF ពហុឆានែល, you can use the UART interface provided by the module. Here is a step-by-step guide on how to configure the module:
1. Connect the module to your device using the RXD and TXD pins of the UART interface.
2. Make sure the module is powered by supplying 5V to the VCC pin.
3. To enter the configuration mode, drive the CONFIG pin low.
4. Send the desired configuration commands to the module through the UART interface. The available commands can be found in the Radiocrafts TM/RC232 Configuration and Communication Tool (CCT) User Manual, Radiocrafts RC232 User Manual, and RC11xx-RC232 Datasheet (RC1190-RC232).
5. After configuring the module, you can exit the configuration mode by driving the CONFIG pin high.
6. The module will now operate according to the configured settings.
សូមយោងទៅលើការផ្តល់ឱ្យ ការណែនាំអ្នកប្រើប្រាស់ for more detailed information on the configuration process and available configuration commands.
បន្ថែមមតិយោបល់ថ្មី។