សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ឧសភា 03, 2025 - 01:09 AM
ដើម្បីដំឡើង VOLT VPL-1050-4-BBZ Modernelle Brass Path and Area Lightសូមអនុវត្តតាមជំហានទាំងនេះ៖
1. Ensure that the power is turned OFF before installing or servicing the fixture.
2. Note that the fixture should not be installed within 10 feet (3 meters) of a pool, spa, or fountain.
3. This fixture is designed to be used with a power supply (transformer) rated maximum of 300 watts (25 AMPស) នៅ 15 វ៉ុល។
4. The underground low energy cable should not be buried over 6 inches (15.2 cm) to connect to the main low voltagខ្សែអេ។
5. Make sure to use UL Listed wire connectors suitable for the application when making wiring connections.
6. Position the wire connector within 6 inches (15.2 cm) from a building structure, luminaire, or fitting.
7. Before starting the installation, turn off/unplug the fixture and allow it to cool before touching or replacing the lamp.
8. When handling the lamp, use a soft cloth and avoid touching it with bare hands, as oil from the skin may damage the lamp.
9. Do not operate the fixture with a damaged or missing lens or shield.
10. The package should contain one fixture body. Additional parts required, such as a mounting accessory and a flat bi-pin LED bulb, are sold separately.
11. To install the bulb, remove the lens by loosening the screws with a screwdriver. Insert the bulb with the correct wattage and type marked on the fixture label and push it into place.
12. Secure the lens back onto the shade by tightening the screws until snug with a screwdriver.
13. Install the stake by hammering it into the ground until the flange of the stake is flush to grade. If the ground is hard, you can make a crosscut using a flat shovel to ease installation.
14. Pass the supply wires through the center hole of the stake and thread the stem onto the stake. Hand tighten until snug. Lay the supply wires into the wireway slots.
15. Strip two leads from the fixture wires and connect them to the main supply cable leads using UL listed wire connectors.
16. To replace the bulb, reverse the steps mentioned above, ensuring that the correct wattage and type marked on the fixture label are used. Always protect the bulb from moisture and dust by reinstalling the lens when removed.
For further assistance, you can contact the VOLT Lighting Help Hotline at 1-813-978-3700, Monday to Friday from 8am to 8pm, and Saturday to Sunday from 10am to 6pm (EST).
បន្ថែមមតិយោបល់ថ្មី។