សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ឧសភា 02, 2025 - 03:01 AM
ដើម្បីដំឡើង និងប្រើប្រាស់ Beta Precision Digital Electronic Ruler for non-contact measurements, follow these steps:
1. Mounting the microscope:
- Attach the clear plastic plate to the digital readout, ensuring the microscope base fits into the groove on the mounting hole.
- Squeeze the base of the microscope and press one edge into the groove, then move the opposite edge into place. The microscope should be firmly held in place.
2. Basic instructions for measurement:
- Press the ON/OFF button to activate the display.
- Rotate the upper black ring to bring the reticle into sharp focus.
- Slide the readout close to the end position and place it in the final position.
- Use the large knurled ring to bring the image into sharp focus.
- Turn the lower black ring to align the reticle to the image.
០៦.០១. មុខងារបង្ហាញ៖
- Press the ON/OFF button and then the mm/inch button to select the unit of measure.
- Rotate the entire microscope body to align the crosshair to the 12, 3, 6, and 9 o'clock positions.
- Use the black eyepiece focus ring to bring the scale into sharp focus.
- Align the microscope crosshair to the start position and press the 0/ABS button until 0.00 appears in the display.
- Move the microscope and slide assembly to the end of the object, adjusting the focus if needed.
- Use the fine motion thumb roller to position the crosshair precisely over the end of the object.
- Read out the total length of the object on the display, and press the mm/inch button to change the unit of measure.
- Press the ON/OFF button to power down the display when all measurements are complete.
For more detailed instructions and information on maintenance, calibration, and recommended microscopes, please refer to the Beta Precision Electronic Rulers Instruction Manual.
បន្ថែមមតិយោបល់ថ្មី។