សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ឧសភា 02, 2025 - 12:41 AM
ដើម្បីដំឡើង បំពង់ LED JESLED T8 4FTសូមអនុវត្តតាមជំហានទាំងនេះ៖
Step 1: Before starting the installation, ensure that the power is turned off at the main circuit breaker and remove the existing bulbs from the fixture.
Step 2: Open the fixture and examine the wiring. Identify whether your fixture has an Electronic Ballast or a Magnetic Ballast. The wiring diagram for a typical fluorescent fixture using single-pin, stationary/plunger-type sockets is provided in the manual. If your fixture has a different wiring configuration, please contact JESLED support at support@jesled.com for assistance.
Step 3: Remove or bypass the ballast as indicated in the wiring diagram. Cut or disconnect the wires in the specified locations. Leave enough wire to allow rewiring of the sockets to the line and neutral as shown in the diagram in step 4.
Step 4: Connect the Live wire to one side (single-wire plunger sockets) and the Neutral wire to the other side (double-wire stationary sockets) as shown in the diagram. Ensure all wire connections are securely wire nutted and wrapped with electrical tape. Also, make sure the fixture is properly grounded before reassembling.
Step 5: Install the new LED tubes into the fixture.
Please note that rewiring of fluorescent fixtures for use with LED tubes should only be performed by individuals who have been properly trained in basic electrical maintenance and repair. It is crucial to follow these instructions thoroughly to avoid any damage or safety hazards.
ប្រសិនបើអ្នកមានសំណួរបន្ថែម ឬត្រូវការជំនួយ អ្នកអាចទាក់ទងបាន។ JESLED customer service at support@jesled.com or visit their webគេហទំព័រនៅ www.jesled.com សម្រាប់ព័ត៌មានបន្ថែម។
បន្ថែមមតិយោបល់ថ្មី។