សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 30 ខែមេសា ឆ្នាំ 2025 - ម៉ោង 10:59 ព្រឹក
ដើម្បីដំឡើង ស្លាកលេខ VIMAR 0K21666.7 គ្រីស្តាល់ horizontally or vertically, follow these steps:
1. Hooking on the cover plate (until it is fully aligned with the mounting frame):
- For horizontal installation: Align the cover plate with the mounting frame and hook it on until it is fully aligned.
- For vertical installation: Align the cover plate with the mounting frame and hook it on until it is fully aligned.
2. Removing the cover plate:
- To remove the cover plate, simply unhook it from the mounting frame.
Please note the following installation rules:
- The kit should only be used with transponder readers art. 21457 and 21457.1.
- The maximum xxxx tightening torque should not exceed 0.3 Nm.
- The IP55 protection degree is only guaranteed with the cover plates included in the kit and on smooth, seamless surfaces.
- For correct operation, during the reader configuration phase with ETS, deactivate the "Enable bell" parameter (set to 0).
For any additional information or specific installation instructions, please refer to the VIMAR 0K21666.7 សៀវភៅណែនាំអំពីគម្របបន្ទះគ្រីស្តាល់.
បន្ថែមមតិយោបល់ថ្មី។