សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 23 ខែមេសា ឆ្នាំ 2025 - ម៉ោង 04:47 ព្រឹក
ដើម្បីរួមបញ្ចូល ប្តូរស៊េរី ZWAVE TechniSat into your Z-Wave network, you can follow the instructions provided in the instruction manual. Here is a step-by-step guide:
1. Make sure that your primary Z-Wave controller is in inclusion mode (adding mode).
2. Install the TechniSat Series Switch in its intended position, ensuring that it is disconnected from the mains power.
3. After the wiring and power supply have been properly set up, switch the fuse back on.
4. Activate the SmartStart function in your primary Z-Wave controller and follow the operating steps to add a device. Alternatively, you can manually set up the switch by setting your primary Z-Wave controller to inclusion mode and following the operating steps.
5. Press the upper push-button position (T1) three times within one second.
6. The LED on the TechniSat Series Switch will light up red while it is being added to the Z-Wave network.
7. If the setup is successful, the LED will light up green for 5 seconds.
Once the TechniSat Series Switch is added to your Z-Wave network, you can control it and utilize its features through your Z-Wave controller or other Z-Wave certified devices in your network.
Please note that these instructions are a general guide and may vary depending on your specific Z-Wave controller and setup. It is recommended to refer to the instruction manual provided with the TechniSat Series Switch for detailed and accurate instructions.
បន្ថែមមតិយោបល់ថ្មី។