សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 14 ខែមេសា ឆ្នាំ 2025 - ម៉ោង 08:39 ព្រឹក
To configure the Modbus hardware on the REZNOR 633be0bf27fe1 Signal Pro Controlអនុវត្តតាមជំហានទាំងនេះ៖
1. Set the RS485 serial half-duplex interface.
2. Set the baud rate to 9600.
3. Set the data bits to 8.
4. Set the parity to Even/No parity, depending on the DIP switch address.
5. Set the stop bits to 1.
6. Set the mode to RTU.
For the DIP switch address, use even parity for addresses 0 to 7, and no parity for addresses 8 to 15.
Please refer to the instruction manual for further details and specific instructions on configuring the Modbus hardware.
បន្ថែមមតិយោបល់ថ្មី។