សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 26 ខែមីនា ឆ្នាំ 2025 - ម៉ោង 09:34 ព្រឹក
To connect multiple audio sources to the កូនប្រុសសឺនសិនamp1650 ampកាន់តែចាស់, you can use the local inputs and/or the bus inputs. Here are the steps:
1. ធានាបាននូវ amplifier is in the OFF state and the rear panel power switch is in the down position.
2. Decide on the appropriate Power Sensing Mode (voltage, audio signals, or always on) and set the Sense DIP switch accordingly.
3. If using the voltage លក្ខណៈពិសេសកេះ, ភ្ជាប់ខ្សែពីរ conductor ពីទិន្នផល 12 volt នៃ zone preamp or DC power supply into the 'V Trigger' inputs on the ampកាន់តែចាស់។
4. Connect a pair of RCA cables from each stereo source into their dedicated local source inputs on the ampកាន់តែចាស់។
5. If using the bus inputs, connect the audio source(s) to the Bus A and/or Bus B inputs on the amplifier ដោយប្រើខ្សែ RCA ។
6. Set the channel Input Assignment DIP switches to the appropriate input (Local, Bus A, or Bus B) for each zone.
7. Connect the speakers to their dedicated Speaker Output Block Connectors on the ampកាន់តែចាស់។
8. If the AC cord is disconnected, reconnect it.
9. Push the power switch up to the ON position.
10. Adjust the volume output with the Zone Level controls on the ampកាន់តែចាស់.
By following these steps, you can connect and distribute multiple audio sources to different zones using the Sonance Sonamp1650 amplifier. For more detailed instructions and illustrations, please refer to the owner's manual provided with the ampកាន់តែចាស់។
បន្ថែមមតិយោបល់ថ្មី។