សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 18 ខែមីនា ឆ្នាំ 2025 - ម៉ោង 02:22 ព្រឹក
ដើម្បីដំឡើង ROTOLIGHT SmartSoft Box on your AEOS 2 or AEOS 2 Pro, please follow these steps:
1. Make sure your AEOS 2 or AEOS 2 Pro is turned off and remove the Standard Diffuser or Barndoors if they are installed.
2. Attach the SmartSoft Box to the light and secure it with the provided small xxxx , but do not fully tighten it yet.
3. Install the two provided large M8 knobs and fully tighten them, along with the small xxxx . Note: If you are using the AEOS yoke, you do not need the two large knobs.
4. Connect the SmartSoft Box control cable to the AEOS 2 / AEOS 2 Pro.
5. Turn on the AEOS 2 / AEOS 2 Pro.
6. In CCT mode, press the bottom left icon twice to cycle between brightness and SmartSoft control.
7. Use the on-screen slider or the left Red Control dial to increase or decrease the amount of diffusion. You are now ready to shoot!
Please make sure to update your AEOS 2 or AEOS 2 Pro to the latest firmware before installing the SmartSoft Box. You can find the latest firmware on the ROTOLIGHT webគេហទំព័រនៅ www.rotolight.com/support ។
If you have any further questions or need assistance, please refer to the ROTOLIGHT SmartSoft Box installation guide or contact ROTOLIGHT customer support.
បន្ថែមមតិយោបល់ថ្មី។