សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 13 ខែមីនា ឆ្នាំ 2025 - ម៉ោង 12:15 ព្រឹក
នេះ។ BAPI EZ Pressure Sensor can be mounted using three different methods: DIN rail mounting, snap track mounting, or surface mounting. Here are the steps for each method:
1. DIN Rail Mounting:
- Pull out the blue mounting tabs on the EZ Mount Base.
- Catch the EZ mount hook on the DIN rail.
- Rotate the EZ pressure module down until the bottom mounting tab snaps into place on the DIN rail.
- Connect wires and pressure lines as needed.
2. Snap track Mounting:
- Push in the blue mounting tabs on the EZ Mount Base.
- Snap the EZ Mount base into the board slots in the 2.75 inch snap track.
- Connect wires and pressure lines as needed.
3. ការដំឡើងផ្ទៃ៖
- Pull out the blue mounting tabs on the EZ Mount Base.
- Place the EZ Pressure unit against the surface and mark the xxxx holes.
- Drill 1/8" pilot holes for #8 flathead screws.
- xxxx the unit to the surface using the elongated holes in the blue mounting tabs for alignment.
- Connect wires and pressure lines as needed.
សូមយោងទៅ សៀវភៅណែនាំឧបករណ៍ចាប់សញ្ញាសម្ពាធ BAPI 49584 EZ for more detailed instructions and illustrations on mounting the sensor.
បន្ថែមមតិយោបល់ថ្មី។