សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 28 ខែកុម្ភៈ ឆ្នាំ 2025 - ម៉ោង 09:54 ព្រឹក
ដើម្បីបន្ថែម Nice Motion-Control Yubii Home to your Z-Wave network, follow these steps:
1. Open the cover of the device.
2. Place the Motion-Control within the direct range of your Z-Wave controller.
3. Set the main controller in (security/non-security) add mode (refer to the controller's manual for instructions).
4. Quickly press the B-button on the Motion-Control three times.
5. Wait for the adding process to complete.
6. The Z-Wave controller will confirm successful adding.
Please note that adding the device in security mode must be done within 2 meters of the controller. If you encounter any issues, you can reset the device and repeat the adding procedure.
បន្ថែមមតិយោបល់ថ្មី។