សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 27 ខែកុម្ភៈ ឆ្នាំ 2025 - ម៉ោង 07:44 ព្រឹក
To change the settings on the LOGICO2 0496 Sniffer Modbus, you will need to remove the cover to access the two DIP-switches. Here are the steps to follow:
1. Identify the DIP-switches on the Sniffer Modbus.
2. Determine the desired settings you want to change. For example, if you want to read-out sensors with ID-number 1 and 2, you will need to set DIP-switch number 1 and 2 to ON. All other DIP-switches should be in the OFF position.
3. If you want to read-out sensors with different ID-numbers, adjust the corresponding DIP-switches accordingly. Each DIP-switch corresponds to a specific sensor ID.
4. If you want to read-out all eight sensors, set DIP-switch number 1-8 to ON. All other DIP-switches should be in the OFF position.
5. Once you have made the desired changes, replace the cover.
Please refer to the manual for more detailed instructions and illustrations on the DIP-switch settings and their corresponding functions.
បន្ថែមមតិយោបល់ថ្មី។