សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 24 ខែកុម្ភៈ ឆ្នាំ 2025 - ម៉ោង 07:26 ព្រឹក
ដើម្បីកំណត់រចនាសម្ព័ន្ធ គ្រប់គ្រង iD iDUHF Access Controller ជាមួយ UHF Readerអនុវត្តតាមជំហានទាំងនេះ៖
1. Connect the device to a power source using the external 12V power supply (not included).
2. Connect the device to your network using the Ethernet port.
3. Access the device's embedded web software by opening a web browser and entering the IP address of the device.
4. ចូល web software using the default username and password provided in the manual.
5. Once logged in, you can customize the access rules and generate specific reports according to your requirements.
6. To configure the UHF reader, go to the UHF Reader section in the web កម្មវិធី។
7. Depending on the tag used and the antenna installation conditions, adjust the reading distance settings for optimal performance.
8. Save the configuration changes and the device is now ready to use.
For more detailed instructions and information, please refer to the Control iD iDUHF Access Controller with UHF Reader Owner's Manual.
បន្ថែមមតិយោបល់ថ្មី។