សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 23 ខែកុម្ភៈ ឆ្នាំ 2025 - ម៉ោង 10:30 យប់
ដើម្បីដំឡើង NICOR DLR56 Recessed LED Downlight Systemអនុវត្តតាមជំហានទាំងនេះ៖
1. បិទថាមពលមុនពេលចាប់ផ្តើមការដំឡើង។
2. Unpack the frame from its packaging and inspect it for any shipping defects.
3. Adjust the hangar bar length, if needed, by separating the bars, snapping them to the desired length at the score marks, and reassembling them.
4. Position the frame between the joists, ensuring that the hangar bars are in the correct position. The bottom edge of the hangar bars should be level with the bottom of the joists.
5. Secure the hangar bars to the joists using the captive nails provided. Start with the swivel foot end of the hangar bar.
6. លើកនិងធានាផ្នែកម្ខាងនៃស៊ុមទៅនឹង joist ពិដាន។
7. ដាក់ស៊ុមនៅកន្លែងដែលចង់បាននៅលើរបារព្យួរ ហើយរឹតបន្តឹងសំណុំ xxxx ដើម្បីចាក់សោស៊ុមនៅនឹងកន្លែង។
8. Connect the building power to the frame junction box. Use the provided quick connectors to connect the black wire to black and white wire to white. Connect the bare copper wire to the ground wire of the power source.
9. Unpack the downlight from its packaging and inspect it for any shipping defects.
10. ប្រសិនបើប្រើការកាត់ពណ៌ស្រេចចិត្ត សូមតម្រឹមកាត់នៅលើអំពូលភ្លើង ហើយធានាវាដោយពត់លើផ្ទាំង។
11. Join the downlight's female quick connector to the frame's male quick connectors.
12. Align the tabs of the frame cap to the depressions on the downlight and snap the cap in place, ensuring that no wiring is pinched.
13. ច្របាច់រ៉ឺស័រទ្រនិចចូលគ្នា ហើយដំឡើងវាទៅក្នុងដង្កៀបទ្រនិចទ្រនិចខាងក្នុងស៊ុម។
14. រុញអំពូលភ្លើងឡើងលើដោយប្រុងប្រយ័ត្ន ដោយធានាថាវាឆេះដល់ផ្ទៃពិដាន។
15. Verify that the downlight system is properly installed.
Please note that this answer is based on the provided instruction manual for the NICOR DLR56 Recessed LED Downlight System. It is important to consult the manual for any specific instructions or safety precautions related to your installation.
បន្ថែមមតិយោបល់ថ្មី។