សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 21 ខែកុម្ភៈ ឆ្នាំ 2025 - ម៉ោង 09:16 យប់
To register a user with a password on the Control iD iDTouch Access Controlអនុវត្តតាមជំហានទាំងនេះ៖
1. Enter Programming Mode by pressing the (*) key to go to Standby Mode, then press (#).
2. The Green LED will start blinking.
3. Enter the programming password (default: 12345) and press (#) again.
4. The Green LED will turn on.
5. Press (1) and then press (#) to register a user with a password.
6. The Green LED will start flashing.
7. Enter the 4-digit user ID and press (#).
8. The device will beep twice.
9. Enter the desired password (between 4 and 6 digits) and press (#).
10. A long beep will indicate successful programming.
11. Press (*) to return to Standby Mode.
Please note that these instructions are based on the information provided in the Control iD iDTouch Access Control User Guide. For more detailed instructions and information, please refer to the user guide provided with your product.
បន្ថែមមតិយោបល់ថ្មី។