សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 07 ខែកុម្ភៈ ឆ្នាំ 2025 - ម៉ោង 03:14 ព្រឹក
ដើម្បីជំនួស right cable (SPCOM00000027) on the N-Com systemសូមអនុវត្តតាមជំហានទាំងនេះ៖
1. Remove the N-Com system from the helmet by referring to the instruction booklet provided with the product.
2. Open the e-box, which is the electronic control box of the N-Com system (refer to Fig. 1-2 in the instruction manual).
3. If necessary, disconnect the antenna connector from the electronic card (refer to Fig. 3-4 in the instruction manual).
4. Remove the old wiring that needs to be replaced and position the new wiring connector in the corresponding counterpart on the electronic card (refer to Fig. 5 in the instruction manual).
5. If you had previously disconnected the antenna, reconnect it to the electronic card.
6. Close the e-box securely (refer to Fig. 6-7 in the instruction manual).
7. Reposition the N-Com system back inside the helmet following the instructions provided in the instruction booklet.
Please note that it is important to refer to the specific instruction manual for your N-Com system model (SPCOM00000027) to ensure proper replacement of the right cable.
បន្ថែមមតិយោបល់ថ្មី។