សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 05 ខែកុម្ភៈ ឆ្នាំ 2025 - ម៉ោង 04:41 ព្រឹក
ដើម្បីដំឡើង TECKNET WA658 Waterproof Plug-in Wireless Doorbell ឥតខ្សែអ្នកមានជម្រើសជាច្រើន៖
1. Adhesive Tape: Apply the double-sided adhesive tape on the back of the receiver or transmitter case. Remove the outer side of the tape and attach the receiver or transmitter to the desired position. Press firmly for 30 seconds to ensure proper adhesion. Note that the stand should not be assembled for the receiver if using adhesive tape.
2. xxxx : There is a xxxx hole in the rear of the receiver. First, tighten a xxxx on the desired position, leaving about 2mm protruding. Then, simply put the receiver on the xxxx , and the installation is complete.
3. Stand: Assemble the included stand on the rear slot of the receiver. You can then place the receiver in the desired position.
It is recommended to complete the music selection and pairing before installing the receiver and transmitter to ensure proper functionality.
សម្រាប់ការណែនាំលម្អិត និងរូបភាពបន្ថែម សូមមើលការណែនាំអ្នកប្រើប្រាស់ដែលបានផ្ដល់ជូន TECKNET WA658 Waterproof Plug-in Wireless Doorbell ឥតខ្សែ.
បន្ថែមមតិយោបល់ថ្មី។