សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 23 ខែធ្នូ ឆ្នាំ 2024 - ម៉ោង 05:52 ព្រឹក
ដើម្បីប្រមូលផ្តុំនិងតំឡើង LAVA 2149 Color Max Volcano Base lampអនុវត្តតាមជំហានទាំងនេះ៖
1. Make sure the lightbulb is tightly screwed into the base.
2. ដាក់អិលamp នៅលើផ្ទៃរាបស្មើ។
3. Connect the power plug to an appropriate outlet.
4. បង្វែរ lamp ដោយប្រើប៊ូតុងបិទ / បើក។
5. អនុញ្ញាតឱ្យ lamp កំដៅឡើងប្រហែល 1-2 ម៉ោងដើម្បីឱ្យលំហូរនិងប្រសិទ្ធភាពល្អបំផុត។
Please note that the first time you start the lamp, it may take 4-6 hours for the lava to flow. The wax may initially form "towery" pillar shapes, which is normal. Allow the lamp to run for at least 4-6 hours the first time you use it.
ប្រសិនបើអិលamp is not flowing properly, check the coil. The coil should be at the bottom of the glass globe, as it helps accelerate the heat to melt the lava at a faster pace. If the coil is not at the bottom, you can easily resolve this by following the instructions in the provided video: [link to video].
ប្រសិនបើអិលរបស់អ្នក។amp appears cloudy, allow it to sit at room temperature and let the wax settle for approximately 8 hours. Then, turn the lamp on until the wax starts to soften, and shut it off until it cools. Repeat this process for 8 to 10 hours, which may result in a clear lamp. If you still think your lamp is cloudy, please contact Customer Service at (800) 336-5282 or email info@lavalite.com.
Please remember to handle the lamp with care and avoid moving, shaking, or dropping it while it's warm, as this can cause the lamp to become cloudy or the lava to break apart. Do not loosen or remove the bottle cap on the globe, as it will ruin the lamp និងលុបចោលការធានា។
For further assistance or troubleshooting, refer to the provided user manual or contact Customer Service at the provided phone number or email address.
បន្ថែមមតិយោបល់ថ្មី។